ENVY airbrush paint Apple Green 50 g

TheENVY Kandy airbrush paint is a Kandy paint designed for airbrush applications, allowing you to achieve a transparent shade with a depth effect.

For application, the recommended method is to mix approximately20% ENVY Kandy withPC Binder Clear. The resulting mixture must then be thinned withShow Up at a ratio of approximately100 to 150%.

To achieve theKandy effect, you must applyMirror Silver Show Up as a base before applying theENVY Kandy.

It is also possible to maintain a good level of adhesion and durability if thePC Binder Clear is applied before and after theKandy layer.

Polyurethane paint :

Use this paint only in a well-ventilated area and with a mask

Precautions :

1. In case of discomfort or unease while using the product, consult a doctor immediately.
2. In case of contact with the eyes, rinse them thoroughly with water.
3. If irritation persists, seek medical assistance.
4. For your protection, wear suitable equipment such as masks, gloves and goggles, and avoid prolonged exposure to vapors.
5. Store the product in a cool place to reduce the risk of fire.
6. KEEP OUT OF REACH OF CHILDREN
7. Do not ingest, in case of ingestion do not induce vomiting and contact a poison control center
8. Do not use near an open flame : flammable liquid

Images are used for illustration purposes only.
Product specifications may be changed without prior notice for improvement or other reasons.

• Brand :Show Up
• Product :ENVY Kandy
• Type : Kandy paint for airbrush
• Capacity :50 g
• Recommended mixing product :PC Binder Clear
• Recommended base for Kandy effect :Mirror Grey Show Up
• Recommended ratio : about20 % ENVY Kandy
• Recommended thinning : about100 to 150 % with thinnerShow Up
• Can be applied with a coat ofPC Binder Clear beforeKandy ENVY
• Can be applied with a coat ofPC Binder Clear afterKandy ENVY
• Helps maintain satisfactory adhesion and resistance

Paintings are only shipped to the following countries:

• Germany
• Austria
• Belgium
• Bulgaria
• Croatia
• Denmark
• Spain
• Estonia
• Finland
• Hungary
• Italy
• Latvia
• Lithuania
• Luxembourg
• Norway
• Netherlands
• Poland
• Portugal
• Czech Republic
• Romania
• Serbia
• Slovakia
• Slovenia
• Sweden
• Switzerland

Recommended pressure according to needle diameter :

• 0.3 mm needle :

• 0.08 to 0.12 MPa (0.8 to 1.2 bar / 11.6 to 17.4 psi)

• 0.5 mm needle :

• 0.15 to 0.18 MPa (1.5 to 1.8 bar / 21.7 to 26.1 psi)

Even spray pattern over a large surface (0.5 mm flat nozzle) :

• 0.2 to 0.23 MPa (2.0 to 2.3 bar / 29 to 33.4 psi)

Important note :

These values may vary depending on the type and viscosity of the paint used. It is recommended to carry out preliminary tests in order to precisely adjust your pressure and achieve an optimal finish.

Macky Works recommends these settings for professional results.

Pressure values may vary depending on the type of paint, the thinning, and the resulting viscosity. It is recommended to carry out preliminary tests in order to precisely adjust the pressure and obtain an even finish. To achieve the Kandy effect, application over aMirror Gray Show Up base is recommended.