M5 MiniZ gyro

Sensitivity gain function

1. Adjust the value of the gain by the transmitter sensitivity channel, ranging from -100 % to 0 to +100 % .A. 0 means no gain.b. -100 %/+100 % is the maximum sensitivity gain.
2. When the gain wire is not used, use the clean potentiometer of the gyroscope to adjust the value of the gain.

Instruction for the function switch

1. EPA (Race setting)

Press the "SW" switch to turn on. The white LED flashes slowly, entering the SERVO race adjustment. Run the steering wheel of the transmitter to stop the servo to the desired position (turn left / turn right). Briefly press the "SW" switch, then the white LED flashes quickly 2 times; The red and green LED becomes solid; And the blue LED flashes slowly. This means that the current race has been saved. Then turn the steering wheel of the transmitter to stop the servo to the other position desired. Briefly press the switch, then the white LED flashes 2 times quickly and remains on afterwards. This means that the current race has also been saved. 2 seconds later, the gyro automatically enters initialization mode. Once the initialization is finished, the gyro is ready for use.

1. Reset (restoration of the default stroke settings)

Press the "SW" switch to turn on and enter the race adjustment mode. After supporting and maintained the switch for 3 seconds, the red LED and the Chartreuse LED begin to flash alternately. 2 seconds later, the default settings are restored. Then he will enter into initialization mode. Once the initialization is finished, the gyro is ready for use.

1. Rounding for the gain

After having double-closted twice on the SW button in normal operating condition, the Orange LED will flash slowly 3 times. Then switch the round trip of the gain.

1. AVC mode

Press the "SW" switch for 2 seconds in operation, then release the switch after the yellow LED flashed twice. Turn between normal mode and AVC mode.

1. X/Y/Z axes adjustment

Press and hold the SW switch for 5 seconds in normal operating condition, and the yellow LED flashes 3 times (please do not release the SW switch when the yellow LED flashes 2 seconds). Then release the SW switch and enter the axes adjustment mode. Under this mode, press the SW switch and the red LED flashes quickly 2 times and remains on. This is the default Z axis. Press the SW switch again and switch to the X axis. The green LED will flash quickly 2 times and remain on. Press the SW switch again and switch to the Y axis. The blue LED will remain on. If you press the SW switch again, you will switch to the Z axis (cycling in this way) again. If you do not rely on the SW switch after entering the axes adjustment mode, the gyro will emerge from the adjustment mode and return to normal operating mode after the white LED has flashed 2 times. The 3 axes adjustment sequence: Z (defect) - x - y - z ...

Note: If you do not release the SW switch after entering the axes adjustment mode, the Gyro will remain in axis adjustment mode until you release the SW switch and the Gyro will come out of the adjustment mode and return to normal operating mode after the white LED has flashed 2 times.

Input signal type

1. If the input period of the analog servo signal is between 10-20ms, the gyroscope output period follows the entry period.
2. Suitable for signal input FUTABA SBUS2 and the release of the 3ms servo period.
3. Suitable for signal input FUTABA SR and the SR output.
4. Suitable for signal input SANWA SSR/on/SHR and the SSR/SHR output.