Nissan S15 WONDER

• Realistic design : The model consists of a three -part body (front, rear and main) to reproduce the impressive design of Wonder Aero in the smallest detail.

• Precise details : The two -story rear fin and the rectification fins on various parts of the body are also reproduced with precision.

• Standard car width : 198 mm at the front and 193 mm at the rear, with two types of wing expansion (+2 mm and +4 mm) included.

• Length : 473.9 mm

• Width : Before 198 mm / rear 193 mm

• wings enlarged in polycarbonate of 2 mm and 4 mm included on each side

• Height : 121.2 mm

• Wheelbase : 258 mm

• Transparent bodywork (front bumper, rear bumper in two parts)

• Aerodynamic parts

• Expanded wings (2 mm width, 4 mm width)

• Inner light pieces

• 3D decal WRAP-UP

• Masking sheet

• Instructions manual

• Painting
• chassis etc.

• The body provided is made of non -painted polycarbonate.

• Painting and assembly are necessary before use.

• The chassis, the mirrors, the interior, the silencer, etc., are not included as standard.

Carrying out a body for a radio -controlled car (RC) can be an exciting project. It allows you to personalize your vehicle to your liking. You will need certain supplies and a little patience. Here is a step -by -step guide on how to make a RC body:

Necessary materials:

1. RC body in polycarbonate/lexan
2. Polycarbonate special spray painting TAMIYA or CREATEX airbrush painting available on the DriftParadiz.fr website
3. Masking band
4. Modelism scissors
5. Ramper and dishwashing liquid or body cleaner TAMIYA

Steps:

1. Preparation : Start by cleaning the polycarbonate body with a soft cloth and dishwashing liquid or body cleaner TAMIYA To remove any oil or dirt. Let dry or use a hair dryer, never use a cloth at the risk of leaving residues in the body.
2. Masking : Use the masking band to cover the areas you don't want to paint right away. You will have to paint by layers, starting with the smallest and clearest details.
3. Paint : Remember that you paint inside the body, so the design must be done upside down. Once you have finished hiding, you can start painting. Be sure to shake the can of paint properly before using it. Spray the paint in thin and uniform layers. Do not try to cover everything in a single layer. It is best to make several thin layers rather than a single thick layer. After painting an area, remove the masking band while the paint is still wet to avoid tearing the paint.
4. Drying and finish : Let each paint layer dry completely before applying the next layer. Once you have finished painting and the paint is completely dry, you can remove all the remaining masking. Then you can cut and mount the body on your RC car.

Remember that making a RC body requires patience and practice. Do not hesitate to experiment with different paint and design techniques to get the look you want.