PC Brush Up Cleaner (900g) - Paint cleaner for Lexan body

1. Cleaner : Soak a clean cloth of PC Brush Up Cleaner And wipe the parts. Before the cleaner dries completely, dry dry with a clean cloth.

2. Anti-static : Spray slightly on the object with an oil -resistant sprayer or a airbrush just before painting. Make sure that the PC Brush Up Cleaner evaporates before you start painting.

3. Corrector : Soak up a cloth or cotton swab of PC Brush Up Cleaner And wipe the areas to be corrected.

4. Stripper : Immerse the objects to be stripped in a container container PC Brush Up Cleaner And regularly check the status of stripping. Reusable several times.

Polyurethane paint:

Use this paint in an airy place and with a mask

Precautions:

1. In case of discomfort or discomfort when using the product, consult a doctor immediately.
2. In case of contact with the eyes, rinse them abundantly with water.
3. If irritation persists, request medical assistance.
4. For your protection, wear suitable equipment such as Masks, gloves and glasses, and avoid prolonged exposure to vapors.
5. Store the product in a cool place to reduce the risk of fire.
6. Do not leave the children's door
7. Do not ingest, in case of ingestion do not have vomit and contacted an anti-poison center
8. Do not use close to a flame: flammable liquid

The images are used for illustration purposes only.
Product specifications can be modified without notice for reasons of improvement or other.

• Adhesion improvement : Use the cleaner to remove contaminants before paint, increasing the adhesion of paintings, masking and decalcomanies.

• Anti-static : By spraying the cleaner on the parts before the paint, it is possible to eliminate static electricity and reduce the support of the dust.

• Corrector : Can be used as a corrector to remove paint overflows caused by masking errors.

• Stripper : Used to remove the paint film after drying, without damaging polycarbonate

Paintings are only shipped to the following countries:

• Germany
• Austria
• Belgium
• Bulgaria
• Croatia
• Denmark
• Spain
• Estonia
• Finland
• Hungary
• Italy
• Latvia
• Lithuania
• Luxembourg
• Norway
• Netherlands
• Poland
• Portugal
• Czech Republic
• Romania
• Serbia
• Slovakia
• Slovenia
• Sweden
• Switzerland

Recommended pressure according to the needle diameter:

• 0.3 mm needle:

• 0.08 to 0.12 MPa (0.8 to 1.2 bar / 11.6 to 17.4 psi)

• 0.5 mm needle:

• 0.15 to 0.18 MPa (1.5 to 1.8 bar / 21.7 to 26.1 psi)

Uniform spray on large surface (0.5 mm flat nozzle):

• 0.2 to 0.23 MPa (2.0 to 2.3 bar / 29 to 33.4 psi)

Relevant note:

These values ​​may vary depending on type and viscosity of the paint used. It is recommended to do preliminary trials to precisely adjust your pressure and get an optimal finish.

Macky Works advises you for these settings for professional results.

Click here to find out who is Show UP