RWD 3.0 mm RWD rocket stops - Rêve D -RD-003-30

RD-003-30 - Spindle Stops rwd 3.0 mm - REVE D

Adjust the steering angle without interrupting the suspension movement!

Aluminum cap Aluminum3.0mm / Ø3.5mm for RD-001 ASL Front Knuckle is now available!

RWD derived cars usually use a spindle stop (steering stop) to set the maximum steering angle, but to maximize the steering angle, many people use M3 adjustment screws.

Even with the M3 adjustment screw, the stop function works, but the screw's surface hinders the suspension movement at the maximum steering angle.

This is where it comes into play!

Unlike the M3 adjustment screw, the surface has no irregularities, so it does not hinder the suspension movement even at the maximum steering angle.

Moreover, as it is made of lightweight aluminum, it is also effective in reducing weight by replacing an iron adjustment screw.

The range consists of a piece of diameter Ø3.0 mm and Ø3.5 mm.

In addition to 3.0mm Ø, which achieves the maximum steering angle, Ø3.5 mm which is an option when you want to slightly control the steering angle is prepared.

Ø3.5 mm is effective when the commercially available Ø4.0 mm has insufficient steering angle and Ø3.0 mm has too much angle!

If you are currently using an M3 adjustment screw as a stop or if you want to increase the steering angle more than a 4.0mm Ø stop, please try it.

◆ RD-003-30: aluminum spindle stop for RD-001 ASL front knuckle (Ø3.0mm, 2 pieces) ¥ 520 (excluding taxes)

◆ RD-003-35: aluminum stop for RD-001 ASL front knuckle (Ø3.5 mm, 2 pieces) ¥ 520 (excluding taxes)

◆ Screw: M3, length 4.5 mm

◆ Pedestal diameter: 5.5 mm

◆ Length from base to tip: 16 mm

◆ Hexagonal hole dimensions: 1.5 mm across flats

* The above dimensions are suitable for the RD-001 ASL front knuckle holder.

* If using for other joints, please check the dimensions of the joint, the front wheel before purchasing.

2 pieces