SBus V3 adapter 4PM/7px/10px/6PV -> Xarvis/Xarvis XX/RAD

OP -15123 -SBUS V3 4 PM/7PX/10px adapter -> XARVIS/XARVIS XX/RAD - ACUVANCE

This adapter allows you to adjust your drive Acuvance with your radio Futaba 4 PM/7PX/10PX. You will need a R334-SB or R334SB-E or R404SB or R404SB-E receiver for it to work.

Here is the new S.Bus link adapter which, in addition to the traditional link function to change the ESC parameters (including MC970CR and MC971CR) compatible with the S.Bus system FUTABA, such as Xarvis XX, and to consult the data newspapers via a transmitter compatible with the S.Bus system of FUTABA, is equipped with a control function that automatically recognizes TAOⅲ when connected simultaneously.

The connection between the receiver and the ESC remains the same as before. Just fix the connector for the TAOⅲ connection, which branches from the body of the adapter (cable length 200mm), at the location of your choice on the chassis, then connect the TAOⅲ to this connector when you use it. It is no longer necessary to replace the cable on the side of the Link terminal during the joint use of the transmitter compatible with the S.Bus and TAOⅲ system, which greatly improves convenience.

Note: the link function with the S.Bus system is identical to that of the S.Bus link adapter (OP-15127), the S.Bus adapter (OP-15067), and SBM-1 (accessory of the MC970CR and MC971CR FUTABA). The cable on the side of the Link terminal which connects to the ESC is removable. By replacing it with our RX cable, you can adapt its length available to your vehicle (the cable on the link side of this product is 100mm).

Note: The transmitter does not have the function of saving the ESC configuration data. Using the TAOⅲ in addition, you can save and manage configuration data, and use various predefined data.

To use the most recent functions, you must update the ESC, this product, the transmitter and the receiver. Please refer to the Xarvis update method here, and the Xarvis XX update method and this S.Bus link adapter here. Please refer to the website of Futaba For the method of updating the transmitter and the receiver.

Note: with the R334SBS / R334SBS FUTABA, You cannot use the telemetry function in T-FHSS SR system mode. If you want to use the telemetry function, please go to T-FHSS system mode.

Note: S.Bus is a communication standard developed by Futaba Electronic Industries Ltd. When you change the settings or perform a telemetry communication with the transmitter, please change the ESC configuration mode to the following modes: for Xarvis: Program card mode (see P.10 of the manual); For Xarvis XX: Link mode (see p.10 of the manual)