PCBinder Transparent adhesion layer

Polyurethane paint:

Use this paint in an airy place and with a mask

Precautions:

1. In case of discomfort or discomfort when using the product, consult a doctor immediately.
2. In case of contact with the eyes, rinse them abundantly with water.
3. If irritation persists, request medical assistance.
4. For your protection, wear suitable equipment such as Masks, gloves and glasses, and avoid prolonged exposure to vapors.
5. Store the product in a cool place to reduce the risk of fire.
6. Do not leave the children's door
7. Do not ingest, in case of ingestion do not have vomit and contacted an anti-poison center
8. Do not use close to a flame: flammable liquid

The images are used for illustration purposes only.
Product specifications can be modified without notice for reasons of improvement or other.

• Dilution: 150% with the Dilution
• Apply it BINDER PC as a hook support before painting on the body.

Paintings are only shipped to the following countries:

• Germany
• Austria
• Belgium
• Bulgaria
• Croatia
• Denmark
• Spain
• Estonia
• Finland
• Hungary
• Italy
• Latvia
• Lithuania
• Luxembourg
• Norway
• Netherlands
• Poland
• Portugal
• Czech Republic
• Romania
• Serbia
• Slovakia
• Slovenia
• Sweden
• Switzerland

Recommended pressure according to the needle diameter:

• 0.3 mm needle:

• 0.08 to 0.12 MPa (0.8 to 1.2 bar / 11.6 to 17.4 psi)

• 0.5 mm needle:

• 0.15 to 0.18 MPa (1.5 to 1.8 bar / 21.7 to 26.1 psi)

Uniform spray on large surface (0.5 mm flat nozzle):

• 0.2 to 0.23 MPa (2.0 to 2.3 bar / 29 to 33.4 psi)

Relevant note:

These values ​​may vary depending on type and viscosity of the paint used. It is recommended to do preliminary trials to precisely adjust your pressure and get an optimal finish.

Macky Works advises you for these settings for professional results.

Click here to find out who is Show UP